WISCO International

Home Page | Manufacturers | ICOM | IC-F70/80S | Quotation Request | Search | E-mail

IC-F70 / IC-F80 Series
SPECIFICATIONS
General
Frequency range
   IC-F70T/S, F70DT/DS
   IC-F80T/S, F80DT/DS 		136-174MHz
400-470MHz
450-520MHz
Number of channels 256 channels / 32 zones
Channel spacing 12.5kHz / 25kHz, 15kHz / 30kHz
PLL channel step 2.5kHz, 3.125kHz (VHF)
5kHz, 6.25kHz (UHF)
Antenna impedance 50Ω
Usable temperature range -30°C to +60°C; +22°F to +140°F
Power supply requirement 7.2V DC
Output power and current
drain (at 7.2V DC; approx.)
 
IC-F70, F70D
IC-F80, F80D
Output Power 5W 4W
Transmit
  		High 2.2A 2.4A
Low (1W)
 		 1.5A 1.5A
Receive
 		 AF Max. 450mA 450mA
stand-by 150mA 150mA
Dimensions (with battery pack)
(Projections not included) 		58.6 (W) × 152 (H) × 38 (D) mm;
25/16 (W) × 531/32 (H) × 11/2 (D) in
Weight (approx.) 400g; 14.1 oz (with BP-235)
430g; 15.6 oz (with BP-236)
 

Transmitter
Max. freq. deviation ±5.0kHz (Wide)
+2.5Khz (Narrow)
Frequency Error ±2.0ppm
Spurious emissions 70dB typ.
Adjacent channel power 70dB/60dB(Wide/narrow)
FM Hum and Noise
   VHF
   UHF
45/40dB typ. (Wide/narrow)
40/35dB typ. (Wide/narrow)
Audio harmonic distortion 3% typ. (AF 1kHz, 40% deviation)
Modulation limiting 60-100% of max. deviation
Ext. Microphone connector 9-pin multi connector / 2.2kΩ
 

Receiver
Intermediate freq. 1st  46.35
2nd  450kHz
Sensitivity (typical)
   Analog (12dB SINAD)
   Digital (5% BER)
0.25µV typ.
0.25µV typ.
Squelch sensitivity
   VHF
   UHF		 (at threshold)
0.25µV typ.
0.32µV typ.
Adjacent Channel Selectivity
   Analog
  
   Digital
 
VHF 80/73dB typ. (Wide/narrow)
78/70dB typ (Wide/narrow)
VHF/UHF 60dB typ.
Spurious response
   VHF
   UHF
80dB typ.
75dB
Intermodulation 75dB (typ.)
Hum and noise ratio 45/40dB typ. (Wide/narrow)
Audio output power 500mW (at 10% distortion with an 8Ω load)
Ext. speaker connector 9-pin multi connector / 8Ω
 

Applicable U.S. Military Specifications
 
Standard MIL 810 C MIL 810 D MIL 810 E MIL 810 F
Method Proc Method Proc Method Proc Method Proc
Low Pressure 500.1 I 500.2 I, II 500.3 I, II 500.4 I, II
High Temp. 501.1 I 501.2 I, II 501.3 I, II 501.4 I, II
Low Temp. 502.1 I 502.2 I, II 502.3 I, II 502.4 I, II
Temp. Shock 503.1 I 503.2 I 503.3 I 503.4 I
Solar Radiation 505.1 I 505.2 I 505.3 I 505.4 I
Rain 506.1 I, II 506.2 I, II 506.3 I, II 506.4 I, II
Humidity 507.1 I, II 507.2 II, III 507.3 II, III 507.4 –
Salt Fog 509.1 I 509.2 I 509.3 I 509.4 –
Dust Blowing 510.1 I 510.2 I 510.3 I 510.4 I
Immersion 512.1 I 512.2 I 512.3 I 512.4 I
Vibration 514.2 VIII, X 514.3 I 514.4 I 514.5 I
Shock 516.2 I, II, V 516.3 I, IV 516.4 I, IV 516.5 I, IV
 
Measurements made in accordance with EIA-152C/204D, TIA-603. All stated specifications are subject to change without notice or obligation.

Options
 
Battery Packs
  • BP-235 Li-Ion BATTERY PACK
    7.4V/1600mAh. Provides 8 hours operating time* (approx.).
    * Tx: Rx: standby=5:5:90
  • BP-236 Li-Ion BATTERY PACK
    7.4V/2400mAh. Provides 12 hours operating time* (approx.).
    * Tx: Rx: standby=5:5:90
  • BP-237 BATTERY CASE
    AA (LR6)×6 alkaline cells. BP-237 is water-resistant, equivalent to IPX4.

Rapid Charger

  • BC-119N DESKTOP CHARGER + AD-110 CHARGER ADAPTER + BC-145A AC ADAPTER
    Raplidly charges the BP-235 in 2.5 hours and BP-236 in 3.5 hours.
  • CP-17L CIGARETTE LIGHTER CABLE
     For Use with the BC-119N (12–16V DC required)
  • OPC-515L DC POWER CABLE
    For Use with the BC-119N (12–16V DC required)
Multi-Charger
  • BC-121N MULTI-CHARGER + AD-110 CHARGER ADAPTER + BC-124 AC ADAPTER
    Rapid charges up to 6 battery packs (six AD-110s are required) in 2.5-3.5 hours.
  • OPC-656 DC POWER CABLE
    For use with the BC-121 (12-20V DC required).

Speaker-Microphone

  • HM-138 SPEAKER-MICROPHONE
    Full sized, waterproof construction equivalent to IPX7.
     (1 m/30 min.).
  • Headsets and PTT/VOX Unit
  • HS-94 HEADSET
    Earhook headset with flexible boom microphone
  • HS-95 HEADSET
    Behind-the-head headset with flexible boom microphone.
  • HS-97 HEADSET
    Throat microphone fits around your neck and picks up speech vibration.
  • VS-1SC PTT/VOX UNIT
    Required when using these headsets
Belt Clips and Lether Belt Hangers
  • MB-93 BELT CLIP
    Swivel type belt clip.
  • MB-94 BELT CLIP
    Alligator type. Same as supplied.
  • MB-96N BELT HANGER
    Swivel type belt hanger.
  • MB-96F BELT HANGER
    Fixed type belt hanger. For use with MB-94.
Activation Software
  • EX-2785 J01 SOFTWARE
    P25 Activation Software
  • EX-2785 J02 SOFTWARE
    DES Activation Software
  • EX-2785 J03 SOFTWARE
    AES Activation Software
Antennas
  • FA-SC56VS ANTENNA
    150-162MHz stubby antenna.
  • FA-SC57VS ANTENNA
    160-174MHz stubby antenna.
  • FA-SC73US ANTENNA
    450-490MHz stubby antenna.
  • FA-SC25V ANTENNA
    136-150MHz antenna.
  • FA-SC55V ANTENNA
    146-174MHz antenna.
  • FA-SC25U ANTENNA
    400-430MHz antenna.
  • FA-SC57U ANTENNA
    430-470MHz antenna.
  • FA-SC72U ANTENNA
    470-520MHz antenna.
  • Interface Cables
  • OPC-966 CABLE
    RS-232C interface cable for connecting with a PC.
  • OPC-1533 CABLE
    H    andy to mobile zone copy cable
  • OPC-1536 CABLE
    Handy to handy zone copy cable

Internal Units

  • UT-109 INTERNAL UNIT
    Provides 32 non-rolling type scrambling codes. Version 01 required.
  • UT-110 INTERNAL UNIT
    Provides 1020 rolling type scrambling codes. Version 01 required.
  • UT-111 INTERNAL UNIT
    Provides LTR® trunking capabilities. Optional internal unit should be installed at an authorized Icom service center only.
  • UT-120 INTERNAL UNIT
    Provides P25 hardware capabilities. Version 01 required.
Optional internal unit should be installed at an authorized Icom service center only.

Antenna Connector Adapter

  • AD-98FSC ANTENNA CONNECTOR ADAPTER
     Allows you to connect a BNC-type antenna.
    (For maintenance use on    ly).
WISCO International, Inc. - MIAMI, FL U.S.A.
Fax: (954) 370-3997 | E-mail: wiscointl@wiscointl.com

Home Page | Manufacturers | ICOM | IC-F70/80S | Quotation Request | Search | E-mail