 |
 |
|
|
|
Specifications |
| General | TK-6110 |
|
Frequency Range Type 1 Type 2 |
|
| Number of channel | 32 |
Channel Spacing |
20, 25 kHz |
| PLL Channel stepping | 5 kHz |
| Operating voltage | 13.6 V DC |
|
Current drain Standby Receive Transmit |
|
| Duty cycle | Transmit: 20% |
| Operating temperature range | -22�F ~+ 140�F (-30� C ~ +60� C) |
| Frequency stability (-22�F ~+ 140�F) |
�0.0005% |
| Antenna Impedance | 50 Ohm |
| Dimensions (W x H x D) | 6-1/4 x 2 x 6-1/4 in.(160 x 50 x 160 mm) |
| Weight (Body only) | 3.5 lbs (1.6 kg) |
|
FCC ID Type 1 Type 2 |
|
FCC
compliance |
|
|
IC certification Type 1 Type 2 |
|
| RECEIVER (Measurements made per EIA/TIA-204D) | TK-6110 |
| Sensitivity (12 dB SINAD) | 0.25�V |
| Selectivity | 75 dB |
| Intermodulation distortion | 70 dB |
| Spurious response | 70 dB |
| Audio output | 10 W at less than 5% distortion |
|
Band Spread Type 1 Type 2 |
|
| TRANSMITTER (Measurements made per EIA-152C) | |
| RF power output | 70 W |
| Type of emission | 16K�F3E |
| Harmonics | 62 dB |
| FM noise | 50 dB |
| Microphone impedance | 600 Ohms |
| Audio distortion | Less than 3% |
|
Band Spread Type 1 Type 2 |
|
|
| Standard | MIL
810C Methods/Procedures |
MIL
810D Methods/Procedures |
MIL
810E Methods/Procedures |
| Dust | 510.I/Procedure I | 510.2/Procedure I | 510.3/Procedure I |
| Vibration | 514.2/Procedure VIII,X | 514.3/Procedure I | 514.4/Procedure I |
| Shock | 516.2/Procedure I, II, X | 516.3/Procedure I, IV | 516.4/Procedure I, IV |
|
WISCO International, Inc. -
MIAMI, FL U.S.A. Fax: (954) 370-3997 | E-mail: wiscointl@wiscointl.com |
